PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : What grease/oil should I use and where?


kanzleramt
06.11.2002, 19:26
A: Good lubrication is very important in the Matrix, and solves a lot of "mystery" leaks and bolt-stick. Paintball gun oil works well, but does not last very long. Do not use oil made for firearms. Some people use DOW 33 (Shocker grease) but it is a little expensive and kind of sticky. White lithium grease works well, isn't sticky, is cheap and found at any hardware store. Grease will last longer than oil, but the bolt seems to cycle easier with oil. Fatty recommends white lithium grease, then some oil on that & a few drops through the ASA:

O-rings are the ONLY contact points, but you should put a little extra grease and oil on all parts as to have a reserve of sorts.
What you should make slippery:
Front wall
Cylinder
Top Hat (VERY CRUCIAL YOU LUBE THIS WELL)
Bolt (get it ALL lubed up)
Back wall
Rear plug

Get all the bolt contact points lubed up, and you will have much smoother function.

mr_belgium
07.11.2002, 08:12
matrix muck, gibt es von the matrix center (http://www.thematrixcenter.com). ist speziell für die matrix gemacht. es kann aber auch sein, dass es von aardvark war???
verwirrt.... muss mal meine favoritenleiste durchchecken ;o)

sh0rt
07.11.2002, 08:56
BattleLube by TMC
Matrix Mub by Aardy

Ick nutze immo Battlelube das macht keinen schlechten eindruck :)
Ich habe auch shockerfet getestet da hab ich ne tube ne große :)
aber irgendwie is das bischn sticky...tut aber auch seinen zweck...

Gutes Tutorial: How to Pfleg my Bolt gibbet und: Aardvark (http://www.aardvarkdirect.com)

mr_belgium
07.11.2002, 09:04
stimmt, so war das! danke dir für die schnelle antwort!
es gibt aber auch leude, die mischen sich selber ihr gebräu aus dem zeug was o.a. wurde und verschiedenen ölen...

kanzleramt
07.11.2002, 09:18
Hat jemand Lust ne deutsch Matrix Seite zu machen und/oder die Anleitung zu übersetzten ??? Ich glaub ich muss noch mal zu RTL2 "der Englischkurs" *grins*


wie rum kommt der Spacer noch mal rein ?:confused:

fierce
07.11.2002, 09:22
Original geschrieben von kanzleramt
wie rum kommt der Spacer noch mal rein ?

Die Einbuchtung muss in Richtung BoltTip zeigen.

kanzleramt
07.11.2002, 09:27
also richtung front wall ?

fierce
07.11.2002, 09:33
ja, Richtung Frontwall, Beercan, Bolttip, Lauf, Breech, Tophat... such Dir eins aus. ;)